您的罗斯勒产品世界指南

Structural Steel FAQ, Part 11 – Preservation Lines

Structural steel components are prone to rust quickly and fail with potentially catastrophic consequences if not covered with a suitable, protective coating. In preparing for use in construction , shi

Paul Hafner relies on further mass finishing machines of Rösler!

Paul Hafner invests in an automated linking system consisting of a loading unit, two rotary vibrators, two dryers and two buffering chutes. Therein the stamped parts are deburred for a perfect surface

New, ultra-modern premises of the Rösler Academy inaugurated!

For more than 80 years, the Rösler Group has been setting international standards with solutions for surface treatment in the areas of mass finishing and shot blasting. The Rösler Academy was founded

Structural Steel FAQ, Part 10 – Blast Rooms for Touch-Ups

When it comes to shot blasting complex weldments like the chassis for construction equipment, excavator booms, and wind power components, sometimes even the best turbine placement may not clean all th

Medical Instruments, Part 3 – Adjusting Surface Finishing Alongside Medical Advances

All medical technology requires precise surface finishing to ensure safety, strength, and longevity. The specific surfacing goal and technique vary though. From stainless steel dental drill heads that

Spinal Implants, Part 2 – Processed to Perfection

Along with the material choice discussed in Part 1 of our Spinal Implants series , surface treatment is the most important factor affecting the functionality, performance, and longevity of spinal impl

Medical Instruments, Part 2 – Mass Finishing or Shot Blasting, Which Technique is Best?

The medical industry is constantly looking for better, more suitable materials that will offer greater performance and longevity for medical devices, implants, and instruments while simultaneously sea

Aluminium castings in a Rösler wire mesh belt machine

Since the end of 2018 MMG Marsberg has been processing a wide range of aluminium castings in a Rösler wire mesh belt machine RDGE 1250 F. For MMG Marsberg this special blasting system designed for fou

ADAC TOTAL 24h Race Nürburgring 2019

The ADAC TOTAL 24h Race Nürburgring 2019 is history. After the pole position, we had great expectations. Unfortunately our #2 AM Solutions Mercedes-AMG GT3 retired from the race after a collision duri

GIFA 2019 / Rapid.Tech

The international foundry trade fair GIFA 2019 will start shortly in Düsseldorf. Our experts from the fields of mass finishing, shot blasting and 3D post processing are looking forward to your visit i

Medical Instruments, Part 1 – Surface Finishing Requirements for Medical Instruments

Rosler Metal Finishing understands that medical instruments are subject to stringent quality standards. Whether during an office visit or a complicated surgery, material defects or malfunctions may cr

Achieving Specific Finishes for Trauma Implants

In our last trauma implant blog, Rosler Metal Finishing discussed the materials used in trauma implants. From hip replacements to cranial plates, there are numerous uses for trauma implants; each with

RAPID + TCT Event May 20-23

Mark your calendars for RAPID + TCT Event May 20-23! Be sure to attend our CEO Bernie Kerschbaum 's session on May 22 about post processing of metal AdditiveManufacturing parts and visit us in Booth 3

Experience quality and technology live: Rösler - Continuous feed single strand blast machine!

In the many steel processing branches of industry, billets/semi-finished parts are important precursors to high quality requirements. Compared to other methods, e.g. staining, the Rösler RKL single-li

Structural Steel FAQ, Part 9 – Removing Residual Blast Media and Dust

After shot blasting, structural steel components often require some cleaning. The degree of cleaning depends on the work piece’s condition prior to processing as well as machine set-up. This installme