搜索

Searched for 2 in 1 pen blue and red ballpoint pen.

Displaying results 1 to 10 of 27.

A Holistic Look at Automated Blasting in the Modern Metal Fabrication Shop

flat plate and beams of various shapes and sizes. FIGURE 2. Turbines emit [...] blasting and painting line in-house, not only because it increases throughput [...] employees working in fresh, filtered air. Yes, some operations in fabrication

Mass Finishing Work Piece Handling Series, Part 1 – Selecting the Best Work Piece/Media Separation Method

fixtures in the machine, components and media loosely tumble in mass finishing [...] remains in the machine and the parts are separated via built-in separation [...] be viable. Signs of inadequate separation may include the need for too much

Mass Finishing Machine Settings Series, Part 2 – Determine Imbalance Weight Settings for Consistent Results

clockwise and counterclockwise including the Rosler “R” machines and gate clearing [...] processing intensity. Additional information can be found in our Using [...] not already integrated, installation of a frequency inverter for precise

Wet Blasting Equipment & Media, Part 5 – Careful Media Selection, Additive Use Impact Results

series includes: Part 1 – “Machines Range in Complexity, Uses.” Part 2 – “Technical [...] cleaning and paint preparation. Glass beads – Useful in wet cleaning and light [...] issue. In such cases, a water hardener is useful in eliminating and/or avoiding

Mass Finishing Process Water, Part 1 – Understand When to Balance Flow or Flood the Process Bowl

stability and success of a process. If inadequate compound and water are [...] What Goes In, Must Come Out Compound and water fulfill distinct and important [...] dirt, and oil from the work pieces; burnishes and brightens them; and keeps

Surface Preparation Standards, Part 2 – Dust Measurements and Considerations

horizontal surfaces, the interior of pipes, and inside structural cavities. [...] visible under 10x magnification. 1 – Particles are visible under 10x magnification [...] corrected vision; usually between 50 and 100 μm in diameter. 3 – Particles are clearly

Centrifuge Technology, Part 5 – Potential Issues and Remedies for Water Recycling

deposits in the form of media and metal fines in the water tanks and the piping [...] for assistance and innovative solutions. Previous posts in the Centrifuge [...] Trial and error are often the origin of innovation. As such, mass finishing

Mass Finishing Water & Compounds, Part 2 – Precise Water Flow, Dosing Drive Results

compounds , and process water must be evaluated individually and as a whole [...] The dosing pump (1) injects the compound directly into the machine. Specific [...] between 0.4 to 2% of the water flow. A freshwater inlet (2) serves as a manual

Mass Finishing Water & Compounds, Part 1 – Identifying, Correcting Hard and Soft Water Issues

processing issues including ineffective finishing and system damage. Water [...] water condition and processing needs. Optimal Range (125 ‐ 260 ppm) – This [...] be increased until the work pieces are clean and free of spots. In some

wet blasting technology, part 4 - typical wet blasting applications

Ra = 1,000 micro inches down to Ra = 40-60 micro inches (25 µm to 1–1.5 [...] applications including: Dies and molds such as die castings and tire and glass [...] absolutely necessary in the aviation and space industries . Shot peening is