Поиск

Искал living in the uk vs us.

Отображение результатов с 111 по 120 из 132.

Spinal Implants, Part 2 – Processed to Perfection

implants and instruments. During the manufacturing process they may have to [...] high as Ra = 800 micro inches, while the initial surface roughness of a [...] as low as Ra = 0.8 micro inches. Uses include deburring/edge radiusing

Medical Instruments, Part 2 – Mass Finishing or Shot Blasting, Which Technique is Best?

medical instruments. This blog will dive deeper into the techniques used in [...] hing all the way to placing the final, finishing touch in the form of [...] feet/second. The impact on the work piece surface produces the desired cleaning

Medical Instruments, Part 1 – Surface Finishing Requirements for Medical Instruments

pieces used in the medical industry is one of our passions. In a series [...] we’ll discuss the various technologies used for finishing the surface of medical [...] cs, but never for invasive instruments. Instruments are sometimes plated

Achieving Specific Finishes for Trauma Implants

before they receive their final finish. Before insertion into the body, [...] handle all materials that are used in the production of trauma implants [...] processes and eliminate the quality fluctuations inherent in manual finishing

Structural Steel FAQ, Part 9 – Removing Residual Blast Media and Dust

often included in the machine. This allows the machine to monitor the height [...] that of the pieces surfacing in the first place as discussed in Part 1 of [...] system at the machine exit. By adding a rotary brush at the end of the process

The Importance of Material Selection in Trauma Implants

materials are used in trauma implants? The answer, in short, is usually stainless [...] titanium. Does the material performance affect the selection? In order to select [...] the specific performance attributes of the implant they are creating. Implants

Structural Steel FAQ, Part 8 – Are All Turbines Created Equal?

accelerate and throw the blast media against the workpieces. They are for shot [...] performance of the respective machine or vehicle including the speed of a sports [...] Because of the large workpiece envelope, the travel distance of the blast media

Structural Steel FAQ, Part 7 – Comparing Commonly Used Blast Machines

for end-use. The particulars of each machine largely depend on the size and [...] of the specific components in need of preparation. This installment of [...] feet wide, they are limited to heights of 24 inches. Using a through feed

Optimal Media Mix, Part 2 – Understanding Media Consumption

settings – The more aggressive the machine settings are – for instance higher [...] abrasive minerals in them, both of which factor into consumption. Media [...] edges and corners increase wear rates. Media load in the machine – Similar

Optimal Media Mix, Part 1 - Identifying and Maintaining Proper Levels

getting stuck in the middle of the bowl, and increased processing times [...] makeup of the mix also effect the pressure of the media on the part. Gaps between [...] The best mass finishing equipment is useless without the proper media.

«
‹
1
2
3
4
5
6
7
8
9
10
11
12 (current)
13
14
›
»