Zoeken

Gezocht naar restaurants with a view.

Resultaat 171 tot 180 van 205.

Joint Reconstruction, Part 6 – Shot Blasting for Surface Finishing, Coating Preparation, and Increased Component Life Span

slurry is achieved using a special pump and compressed air. Advantages of wet [...] Another advantage of air blasting is that it can be used with metallic [...] bombarded with a stream of blast media. Each pellet forms a little dimple

Joint Reconstruction, Part 5 - Mass Finishing for Smooth, polished surfaces

finishes on a wide array of implants, not only with absolutely repeatable [...] finishing is a highly versatile finishing technology that can be used for a wide [...] implants must have a perfect surface finish without any blemishes. Even

Forge & Foundry, Part 7 – Selecting a Shot Blasting Machine for Forgings, Non-Sand Castings, and Powdered Metal Components

having to deal with this type of dust are equipped with an air wash separator [...] high media impact velocity along with the abrasion of the media/oxide dust [...] excessive pollution within coolant systems, and inefficient adhesion of coatings

Joint Reconstruction, Part 4 – Comparing Surface Finishing Methods

use with additive manufactured parts. Because these parts start with a much [...] deburring, edge radiusing after forging , casting , additive manufacturing, and [...] for screws, and additive manufacturing. The smoothness of a surface is pa

Forge & Foundry, Part 6 – Selecting a Shot Blasting Machine for Die Castings

replacing the auger with a vibratory screen conveyor that allows the automatic [...] are equipped with an air wash separator that safely removes all of these [...] Foundry Series continues with tips for selecting a shot blasting machine for

Joint Reconstruction, Part 3 – Surface Finishing Standards

replacements are already made with additive manufacturing with great success [...] interacting with each other with Ra readings of < 1.0 micro inches. A textured [...] finish – be it a high-gloss polish for low friction, a textured surface

Forge & Foundry, Part 5 – Cleaning Features & Dust Precautions for Sand Castings

require turbines with a lot of fire power. Turbines with curved throwing [...] must not only be able to cope with extremely abrasive sand and scale/rust [...] Forge and Foundry Series continues with a look at the cleaning required for

Joint Reconstruction, Part 2 – Material Standards

(right) is shown with an acetabular cup lined with ceramic and a ceramic femoral [...] example, the acetabular cup of a hip implant can be lined with polyethylene [...] plate interacting with the femoral head is protected with a polyethylene liner

Forge & Foundry, Part 4 – Selecting a Shot Blast Machine for Sand Castings

we work with our clients to learn about their process, develop a better [...] asked: Are the parts sturdy, allowing for aggressive processing, or must they [...] extremely important to find a supplier that can offer a machine that is perfectly

Forge & Foundry, Part 3 – Shot Blasting & Sand Castings

than 60 percent of all metal castings are made with a sand casting process [...] usually “glued” together with a bonding agent like clay, water, oil, resin [...] Forge and Foundry Series continues with a deeper look at sand castings. While

«
‹
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18 (current)
19
20
21
›
»